Electronic Design

  
Reprints     Printer-Friendly    Email this Article    RSS        Font Size     What's This?


[TechView: Analog & Power]
Motor-Monitor/Vibration-Analysis Chips Have It All

Don Tuite  |   ED Online ID #11648  |   December 15, 2005


In designing wireless sensor network (WSN) machine monitoring and vibration analysis, the physical size of the sensor end-point modules must be minimized. To meet that goal, Quickfilter offers a monolithic four-channel alternative to using a DSP and supporting components for the edge-of-network filtering function.

The QF4A512 provides software-configurable input voltage ranges and gain settings for each channel. Its software-configurable anti-aliasing filters then handle signals from dc up to several hundred kilohertz. Next, it offers a software-configurable 16-bit analog-to-digital converter (ADC) and programmable digital filtering.

Each channel has an input range from dc to 1.0 MHz. The chip's tunable anti-aliasing filters (AAFs) implement a third-order Bessel function (linear phase) architecture. Cutoff is either 500 kHz or 3 MHz. A pipeline ADC that has a 12-bit ADC architecture follows the AAF.

However, the ADC can provide up to 16-bit resolution by oversampling the input and averaging the resultant conversions. And while the ADC can run up to 75 Msamples/s, achieving a 13.5-bit ENOB will limit designers to 1.17 Msamples/s.

Cascaded-integrator comb filters apply gain and offset correction. They also handle decimation/down-conversion of the oversampled data. Then, a set of cascaded-integrator half-band filters integrates to 16 bits and decimates to the desired sample rate.

Following that, each channel has its own user-programmable 512-tap digital finite-impulse response filter. Engineers can configure each filter as low-pass, notched low-pass, high-pass, band-pass, dual band-pass, band-stop, or dual band-stop.

Setup is via a GUI-based design tool that configures the complete signal path for all four channels and writes the information and filter coefficients to EEPROM on the chip. Reprogramming can take place in-circuit via the chip's serial-peripheral-interface bus interface.

The QF4A512 costs $9.89 each in quantities of 1000. Packaging is a 32-pin low-profile quad flat package. A full development kit is available for $199 online from the Quickfilter Web site or from Mouser (see the figure).

Quickfilter
www.quickfiltertech.com


Reprints   Printer-Friendly  Email this Article  RSS    Font Size   What's This?


  • Network-On-Chip Tools Arrive for The Masses
  • Tackling System Design Challenges Through Early Verification
  • ESL Tools Take Center Stage As Designers Move Up
  • Parasitic Extraction Tool Targets Next-Generation Custom ICs
  • Synopsys Jumps Into ESL-Synthesis Pool
  • Verify Control Systems Before Committing To Hardware
  • You're Using How Many FPGAs?
  • Tool Up For The FPGA Blitz
    1) Build A Smart Battery Charger Using A Single-Transistor Circuit
    (182 views today)
    2) Hot Hands For Some Cool Rock: Motion Sensing Meets Audio Engineering
    (167 views today)
    3) What's All This Transimpedance Amplifier Stuff, Anyhow? (Part 1)
    (74 views today)
    4) GPS-Derived Grandmaster Clock Delivers Ultra-Precise Time And Frequency Sync
    (70 views today)
    5) Downconverting Mixers Lower Power Consumption While Improving Performance
    (55 views today)
    ALL TOP 20



    POST YOUR COMMENTS HERE
    Name:

    Email:
    Your Comments:

    Enter the text from the image below


    Please refresh the page if you have trouble reading this text.

    Search Electronic Design
         
      
     
    Email Newsletter
    Sponsored By:
    Electronic Design UPDATE provides readers with late-breaking news, opinions from industry experts, and timely technology stories. It's a unique opportunity to get your product message in front of engineers, engineering managers, and corporate managers while they're reading about critical information online.

    Enter Email to Subscribe
      

    Electronic Design Europe Electronic Design China EEPN Power Electronics Auto Electronics Microwaves & RF
    Mobile Dev & Design Schematics Find Power Products Military Electronics EE Events Related Resources