RF gain blocks (amplifiers) are popular because they offer wide bandwidth, low noise, and ease of use. They're designed to operate with a fixed value of supply current because variations in supply current cause variations in the gain, compression point, and other crucial specifications.
Typically, a series resistor sets the supply current to a value based on the known value of dc voltage at the RF choke. That voltage, however, can vary from part to part. For instance, the GALI-21 amplifier (from Minicircuits Inc.) specifies a dc output ranging from 3 to 4.1 V.
Therefore, a fixed supply voltage, such as 5 V, allows the supply current to vary ±30%, causing a variation in gain. That behavior is particularly serious in a twochannel system that requires matched gains. To combat this problem, the circuit of the figure produces a constant and uniform source of current that's independent of part-to-part variations.
Active feedback forces the voltages at the op amp's inverting and non-inverting terminals to be equal. Thus, VR1 = VR2, and:
The current ratio is set by resistors R1 and R2, and the gain block's supply current is set by VCC, R1, and R3:
In the example circuit, the GALI-21 specifies a supply current of 40 mA. So with VCC = 5 V, choose R2 = 2Ω (a low resistance), R1 = 1 kΩ, and R3 = 62 kΩ. CNOISE E is an optional noise-reduction capacitor.
Please refresh the page if you have trouble reading this text.
Search Electronic Design
Email Newsletter
Sponsored By:
The Find Power Products monthly newsletter brings you the most important new developments within the world of power design. The newsletter includes exerpts from industry leader Sam Davis's exclusive blog, as well as overviews of the latest new products.
Enter Email to Subscribe
Web Seminar
Sponsored By:
Title: Exploring How Good GUIs Drive Adoption in the Digital Power Management Space
Reprints
