Analog signal processing has conventionally been viewed as a voltage-dominated form of design. But voltage-mode processing can restrict the system's dynamic range. There is also a limitation on the input range of signals for linear operation. An approach to overcoming these problems is the use of voltage-to-current signal transformation. Recent advances in this context have opened a new dimension of analog design referred to as current-mode signal processing (CMP).
A novel current-mode second-order bandpass filter (BPF) is presented that can easily provide quality factors as high as 100 while still using nominal component values. Such high-Q filters are particularly important in applications like communication receivers and graphic equalizer displays. The circuit shown in Figure 1 provides a current-mode bi-quad output (for Y1 = sC1 ,Y2 = sC2 ,Y3 = G3, Y4 = 1/sL). Terminal W is the voltage-buffered output. If needed, the circuit can be programmed as a high-pass or low-pass filter as well (see the table).
Analog Devices' AD844, a monolithic current-feedback op amp, forms the heart of the circuit (Fig. 2). A dual-OTA implementation of a synthetic inductor, the LM13600 from National Semiconductor, is used for Y4. This provides the additional advantage of current-tunable filter characteristics. The current-mode transfer function of the BPF is modeled as:
where L = C4/ gM2 and G3 = 1/R3 with IB1 = IB2.
Upon analysis,
where gM is the OTA's transconductance, which is the function of the biasing current. For the bias configuration shown:
gM = IB/2VT
where IB = biasing current.
From these expressions, we can observe that independent control of Q is possible by varying only R3. Varying R3 from 1 to 5 kÙ results in values of Q that range from 20 to 100, respectively.
Over this range of Q values, the other circuit parameters, with ùo = 50 krad/sec (i.e., fC is approximately 7.96 kHz) and with a simulated value of L = 4 H are:
The experimental results for three values of Q are shown in Figure 3. Note that in all the cases as G3 is varied no shift in the natural frequency is observed, confirming the independent Q-factor control.
Please refresh the page if you have trouble reading this text.
Search Electronic Design
Email Newsletter
Sponsored By:
Electronic Design UPDATE provides readers with late-breaking news, opinions from industry experts, and timely technology stories. It's a unique opportunity to get your product message in front of engineers, engineering managers, and corporate managers while they're reading about critical information online.
Reprints
