Adjusting the output voltage of a power supply is a feature typically reserved for highly integrated handheld power-management units (PMUs) with multiple integrated power supplies. You can implement this feature, however, with any power supply by adding a single resistor and an inexpensive digital-to-analog converter (DAC) (Fig. 1). While this technique isn’t new, the equations to select appropriate resistor values are rarely published.

Using nodal analysis on the circuit in Figure 1 provides the fundamental equations:

You can easily derive the equations for the three resistors using these fundamental equations and the knowledge that the DAC voltage is inversely proportional to the output voltage. For example, when V_OUT = V_OL, then V_DAC = V_DACH, where V_OL = the power supply's lowest output voltage and V_DACH = full-scale DAC voltage.

Then, using Eq. 1 and Eq. 2:

So, when V_OUT = V_OH, then V_DAC = V_DACL, where VOH = highest output voltage and VDACL = zero-scale DAC voltage.

Again, using Eq. 1 and Eq. 2:

Substituting and solving for R1, R2, and R3 yields:

The circuit in Figure 2 uses the LM5116 power-supply controller, which has a threshold voltage of 1.215 V, to generate an arbitrary dynamic output voltage ranging between 0.6 V and 5.1 V. The output voltage is adjusted by the DAC081S101, which swings between 0 V and a reference of 5 V. The calculated resistor values for this example are R1 = 3.73 kΩ, R2 = 8.66 kΩ, and R3 = 9.1 kΩ.

Returning to the fundamental equations, you can calculate V_O as a function of the DAC voltage, V_DAC:

The format of Eq. 8 is y = mx + b, which proves that the output voltage is a linear function of the DAC voltage. Figure 3 plots the measured output voltage versus the DAC voltage for the example resistor values calculated above.

When using this method to control your output voltage, ensure that the DAC can drive the chosen resistor values. A unity-gain operational amplifier may be needed to buffer the DAC output. Alternatively, choosing resistor values in excess of 10 k allows just about any DAC to meet this requirement. If you plan to program the output voltage to a value below that of the controller threshold voltage, the DAC must be able to drive a voltage higher than the threshold voltage.

Reprints

Printer-Friendly

Email this Article

RSS

Submit PlanetEE del.icio.us Digg Reddit Newsvine StumbleUpon Netscape Yahoo MyWeb Live Bookmarks Fark  Submit

Font Size

What's This?

Network-On-Chip Tools Arrive for The Masses Tackling System Design Challenges Through Early Verification ESL Tools Take Center Stage As Designers Move Up Parasitic Extraction Tool Targets Next-Generation Custom ICs Synopsys Jumps Into ESL-Synthesis Pool Verify Control Systems Before Committing To Hardware You're Using How Many FPGAs? Tool Up For The FPGA Blitz

1) Build A Smart Battery Charger Using A Single-Transistor Circuit (180 views today) 2) Hot Hands For Some Cool Rock: Motion Sensing Meets Audio Engineering (168 views today) 3) What's All This Transimpedance Amplifier Stuff, Anyhow? (Part 1) (87 views today) 4) GPS-Derived Grandmaster Clock Delivers Ultra-Precise Time And Frequency Sync (77 views today) 5) Downconverting Mixers Lower Power Consumption While Improving Performance (62 views today) ALL TOP 20

Reader Comments well written Anonymous -October 12, 2009
POST YOUR COMMENTS HERE Name: Email:
Your Comments: Enter the text from the image below Please refresh the page if you have trouble reading this text.