Not properly closing a refrigerator door will no doubt invite huge electricity bills. This gadget is an alert device that beeps if you leave the refrigerator door open for more than 20 seconds. When the door opens, the lamp illuminates and the IC (a 4060B counter/oscillator) starts counting down. After a preset delay of 20 seconds, the piezoelectric buzzer beeps intermittently for 20 seconds and then stops for the same amount of time. This cycle repeats until the refrigerator door closes.
Producing a small dc voltage from the ac mains to run an electronic control requires a step-down transformer or a capacitor dropper circuit. This design uses an innovative and easy solution. When someone opens the refrigerator door, the lamp receives power via the diodes in the bridge rectifier, D1-D4, and through the Zener diode, ZD1 (see the figure). The voltage drop across the Zener diode is smoothed by the filter capacitor, C1. This voltage is sufficient to run the rest of the circuitry.
To install the circuit, cut the existing wire as shown in the figure and connect the circuit (shadowed) at points A and B. The circuit can be conveniently placed in the compressor compartment where there’s ample space. With the door closed, the lamp is off and no power goes to the timer circuit.
The circuit runs directly from the mains. So care must be exercised and a little knowledge of refrigeration wiring will ease the job.
can u guide about the details of construction of the fridge alarm circuit given at http://www.techlib.com/electronics/kitchen.html.
Anonymous -October 05, 2009
Note that the only thing that limits current in this circuit is the light bulb. Don't neglect the inrush current when the bulb turns on, and as it burns out.
Kenneth Lundgren -April 06, 2009
Digging into the refrigerator's wiring could get rather messy, and hazardous.
Why not power the circuit with a battery, and use a light sensor?
Better still, use a temperature sensor.
Kenneth Lundgren -April 06, 2009
This is a cool variation on a bridge rectifier. It's probably common, but I haven't run into it before. It's a nice way to get a low DC voltage, if efficiency isn't that important and the DC voltage is low compared to the AC voltage.
My country uses 120VAC, so this circuit would be slightly less efficient for me and might dim the bulb a smidge.
Charles J Gervasi -March 27, 2009
Many newer refrigerators have this built in. The circuit is more useful if it has a separate switch detecting the door is not "completely" closed. The Zener in this circuit carries the full current of the bulb, close to 1/2 amp for a U.S. fridge. This could get a bit warm if the door is left open too long.
Gabor L Szakacs -March 27, 2009
Your Comments:
Enter the text from the image below
Please refresh the page if you have trouble reading this text.
Search Electronic Design
Email Newsletter
Sponsored By:
Electronic Design UPDATE provides readers with late-breaking news, opinions from industry experts, and timely technology stories. It's a unique opportunity to get your product message in front of engineers, engineering managers, and corporate managers while they're reading about critical information online.
Reprints
