This Idea For Design provides an alternative to an earlier IFD that noted that Spice does not have a device model for an ideal transformer (“A Spice Model For The Ideal Transformer”). The author explained, “Instead, Spice provides a coupled-inductor model in the K statement that includes self and mutual inductances.”

The author’s proposed solution is a model that includes a voltage- controlled voltage source coupled with a current-controlled current source that correctly simulates the operation of an ideal transformer, even at dc. He provided a Spice listing for the ideal transformer model and a diagram showing the two sources. Figure 1 shows an example of this model with a turns ratio of n = 2, including an input voltage source and a secondary load resistor.

This model works well for most circuits, but a problem occurs if you reverse the direction of the ideal transformer and try to connect a voltage source to the secondary (Fig. 2). Spice then generates an error message indicating a voltage loop problem. The message indicates that the problem can be alleviated by adding a series resistor:

“ERRORVoltage source and/or inductor loop involving E_E1. You may break the loop by adding a series resistance.” The resistor can be very small, so that it doesn’t significantly affect the results.

The model shown in this Idea For Design represents an ideal transformer that’s truly bi-directional. Either side of the ideal transformer can be driven from a voltage source without creating Spice problems (Fig. 3). The model still needs an extra resistor to keep Spice happy, but this resistor is internal to the model, and it can be very large (say, 1 GΩ or higher).

Another advantage of this model is that the elements are all voltage-controlled current sources. This is helpful for writing a circuit analysis program that uses nodal analysis. I wanted to write a program that finds poles and zeros and then calculates the transient response. I chose nodal analysis, for which voltage-controlled current sources are preferred to other types. The program is written in C++.

Readers who are interested can contact the author to receive example code that will show how to use the ideal transformer model.

Reprints

Printer-Friendly

Email this Article

RSS

Submit PlanetEE del.icio.us Digg Reddit Newsvine StumbleUpon Netscape Yahoo MyWeb Live Bookmarks Fark  Submit

Font Size

What's This?

Parasitic Extraction Tool Targets Next-Generation Custom ICs Synopsys Jumps Into ESL-Synthesis Pool Verify Control Systems Before Committing To Hardware You're Using How Many FPGAs? Tool Up For The FPGA Blitz Support Will Have Android Showing Up In Embedded Apps High-Level Design In EDA—Quo Vadis? (Or, Where Are You Going?) New Power-Management Policies Emerge At DAC

1) Build A Smart Battery Charger Using A Single-Transistor Circuit (182 views today) 2) Hot Hands For Some Cool Rock: Motion Sensing Meets Audio Engineering (163 views today) 3) Bidirectional H-Bridge DC-Motor Motion Controller (69 views today) 4) White LEDs Promise Green Illumination Domination (66 views today) 5) What's All This Transimpedance Amplifier Stuff, Anyhow? (Part 1) (64 views today) ALL TOP 20

Reader Comments Hi, I use to work with a Ken Hatch at LLNL in Livermore, CA. If the author is the same Ken Hatch, would you please ask him to eMail me at the above address. Thanks. Waldo Magnuson Waldo Magnuson -June 29, 2009 Hi, I use to work with a Ken Hatch at LLNL in Livermore, CA. If the author is the same Ken Hatch, would you please ask him to eMail me at the above address. Thanks. Waldo Magnuson Waldo Magnuson -June 29, 2009
POST YOUR COMMENTS HERE Name: Email:
Your Comments: Enter the text from the image below Please refresh the page if you have trouble reading this text.