In today’s world, there are many applications for portable devices. These devices must have extremely low or no battery drain when turned off and need to charge their on-board batteries when connected to an external power supply, whether the device is turned on or not. This circuit provides seamless switching from batteries to external power and provides a simple charging solution. In addition, there are several output signals for a microcontroller (MCU). This application uses a +15-V external dc supply to charge a +12-V lead-acid battery.

When power switch S1 is closed and the charger isn’t plugged in, the 12-V battery powers the circuit. If the user plugs in the charger to recharge the battery (with S1 still closed), U1 cuts off current flow from the battery and provides power to the circuit from the external source only. The +15-V source can provide up to 5 A of current to the load. R1 and R4 are used to signal to the processor when the device is plugged in.

Q1 and Q3 make up the heart of the battery-charging circuit. This has to be driven by the MCU. When the Charge Driver line is high, the battery will receive current from the +15-V source. D2 prevents current from flowing from the battery back into the charging circuit.

R3 and R6 provide a signal for the MCU, indicating when switch S1 is turned on. When the switch is turned off, no current will flow, preventing the battery from draining during storage. In some applications where temperature varies widely, these values may need to be dropped by an order of magnitude or two. R2, R5, and Q4 provide a 0- to 5-V signal related to the voltage level of the +12-V battery. This voltage helps ensure proper charging and gives the user an indication of how much battery life is left.

Because the user may want to charge the battery without turning the device on, the voltage divider needs to connect to the battery directly, without the power switch in its path. As a result, the processor can monitor battery voltage when turned off. Q4 prevents current from flowing when S1 is off and the circuit isn’t connected to the external power supply, again preventing the battery from draining when not in use.

All of these components are readily available and not very expensive. The circuit here is designed for a 12-V battery and a 15-V power supply. For different voltages, some minor tweaks to the monitoring resistor values may be required. In addition, adjustments to the U1 and Q1 circuits may be needed. The good folks at IR are very competent and would be happy to help get your design up and running quickly.

See associated figure

Reprints

Printer-Friendly

Email this Article

RSS

Submit PlanetEE del.icio.us Digg Reddit Newsvine StumbleUpon Netscape Yahoo MyWeb Live Bookmarks Fark  Submit

Font Size

What's This?

Parasitic Extraction Tool Targets Next-Generation Custom ICs Synopsys Jumps Into ESL-Synthesis Pool Verify Control Systems Before Committing To Hardware You're Using How Many FPGAs? Tool Up For The FPGA Blitz Support Will Have Android Showing Up In Embedded Apps High-Level Design In EDA—Quo Vadis? (Or, Where Are You Going?) New Power-Management Policies Emerge At DAC

1) Build A Smart Battery Charger Using A Single-Transistor Circuit (173 views today) 2) Hot Hands For Some Cool Rock: Motion Sensing Meets Audio Engineering (164 views today) 3) Bidirectional H-Bridge DC-Motor Motion Controller (65 views today) 4) White LEDs Promise Green Illumination Domination (63 views today) 5) What's All This Transimpedance Amplifier Stuff, Anyhow? (Part 1) (45 views today) ALL TOP 20

Reader Comments Is R8 considered the load? Anonymous -September 24, 2009 In the diagram, I believe Q1 is not correct. Source and gate should be interchanged. Karsten Sorensen -July 24, 2009
POST YOUR COMMENTS HERE Name: Email:
Your Comments: Enter the text from the image below Please refresh the page if you have trouble reading this text.