Copyright © 2006 Penton Media, Inc., All rights reserved.
Printing of this document is for personal use only.
Reprints

The lower cost and wider availability of network interface cards (NICs) and other optical components have led to the recent upsurge in 10-Gigabit Ethernet (10GE) networking. According to a recent report by research firm IDC, installation of 10GE ports will more than double from 1.4 million in 2007 to over 3 million by 2010 as more and more network switches and other datacom equipment adopt 10GE technology.

Avago’s SFP+ (small form-factor pluggable) optical transceivers will go a long way to helping 10GE adoption as they increase port density while holding the line on power consumption. The AFBR-7000DZ optical transceiver meets the IEEE’s 802.3ae 10GBASE-SR specifications for short-reach optical networking (see the figure). It also uses multimode fiber and provides coverage up to 300 m.

The device uses Avago’s own 850-nm vertical- cavity surface-emitting lasers (VCSELs), which are based on an Avago 4G VCSEL design that has undergone over 2 billion device hours of testing with no failures. The receiver uses a PIN diode detector. Typical power consumption is 600 mW. The transceiver supports the SFF-8431 specification of 10GE SFP+ as well as the SFF-8472 specification for the digital monitoring interface (DMI) in optical transceivers.

The DMI uses an I2C interface to deliver real-time temperature, supply voltage, laser bias current, laser average output power, and received input power information. A digital diagnostic interface also adds the ability to disable the transmitter, monitor for transmitter faults, and monitor the receiver loss of signal.

The AFBR-7000DZ is available now at prices that begin at $200 in reasonable volume. Additionally, the company has a complete line of optical transceivers for other Ethernet standards as well as Sonet and Fibre Channel.

AVAGO TECHNOLOGIES • www.avagotech.com