Part Inventory
Go
powered by:
 
powered by:

 

J. Jayapandian

J. Jayapandian, senior scientific engineer, received a master's in both physics and philosophy in solid-state physics from the University of Madras and Barathidasan, Tamil Nadu, India.


My Latest Content
My Latest Comments



Author Articles

  • Measure Laser Power With A Modified MEMS Pressure Sensor

    Measure Laser Power With A Modified MEMS Pressure Sensor

    By J. Jayapandian, September 19, 2011

    Laser power is usually measured with a thermocouple/thermopile or with photo diodes. But thermopile-based laser power meters depend on the heat the laser generates in the sensor and are usually bulky with a slow response time.

  • Measure Micro-Displacements Using A CD’s Optical Pickup Head
  • Micro-Structured Transducer Accurately Measures Pressure

    By K. Prabakar, December 11, 2008

    Today’s micro- and nano-structured sensors boast excellent linearity, resolution, and wide measurement ranges. As a result, microelectromechanical systems (MEMS) are playing an increasing role in many more applications. This design describes a

  • LPT Port Drives Programmable Slewing-Voltage Control

    By J. Jayapandian, February 17, 2005

    This design modifies a simple first-order, low-pass filter into a slewing-voltage control that is programmable for its slope and amplitude through a PC's LPT port. These control parameters are typically required for metallurgy studies like corrosion o

  • Novel PC-Compatible AC Power Controller Uses Solid-State Relay

    By J. Jayapandian, September 15, 2003

    This design describes a simple, cost-effective solution for an ac power controller using PC-compatible conduction-angle control. A solid-state relay (SSR) is activated through a pulse-width-modulated (PWM) transistor-transistor-logic (TTL) timing...

  • Interface 20-Bit Sigma-Delta ADCs Through A PC's Parallel Port

    By J. Jayapandian, March 04, 2002

    In most sigma-delta analog-to-digital converter (ADC) applications, the serial data transfer occurs through a serial port. A microcontroller configures the serial port as required—setting the baud rate and stop/start bits, initializing the serial...