Heatsinks Fit SSRs

Nov. 1, 1999

Available for a large variety of ratings and case dimensions of solid-state relays (SSRs), these heatsinks offer comprehensive solutions for electronic load relays. The heat sinks have threaded holes for direct fastening of SSRs using screws. To fix heatsinks to support rails, they are fitted with special clip fastenings that are suited to use for all 35 mm mounting rails according to DIN EN 50022.

Continue Reading

Solving the contact resistance challenge for 7nm and beyond CMOS

Flash Memory Takes Over

Sponsored Recommendations

TTI Transportation Resource Center

April 8, 2024

From sensors to vehicle electrification, from design to production, on-board and off-board a TTI Transportation Specialist will help you keep moving into the future. TTI has been...

Cornell Dubilier: Push EV Charging to Higher Productivity and Lower Recharge Times

April 8, 2024

Optimized for high efficiency power inverter/converter level 3 EV charging systems, CDE capacitors offer high capacitance values, low inductance (< 5 nH), high ripple current ...

TTI Hybrid & Electric Vehicles Line Card

April 8, 2024

Components for Infrastructure, Connectivity and On-board Systems TTI stocks the premier electrical components that hybrid and electric vehicle manufacturers and suppliers need...

Bourns: Automotive-Grade Components for the Rough Road Ahead

April 8, 2024

The electronics needed for transportation today is getting increasingly more demanding and sophisticated, requiring not only high quality components but those that interface well...