Electronic Design

Find and Fix Power-Supply Noise Issues When Charging Cells (.PDF Download)

April 11, 2016

During the design phase of a battery-powered product, engineers will need to qualify cells for suitability in the application. This testing often is done with dedicated cell test equipment, but sometimes engineers will turn to standard off-the-shelf power supplies to charge the cells and standard off-the-shelf electronic loads to discharge the cells...

Register or Sign in below to download the full article in .PDF format, including high-resolution graphics and schematics when applicable.

Download

Continue Reading

Solving the contact resistance challenge for 7nm and beyond CMOS

Wearable Skin Patches: The “Hot” Medical Research Field

Compact buzzers, speakers, and microphones provide options for maximum flexibility

Same Sky Devices' diverse range of buzzers, speakers, and microphones are designed to minimize footprints and maximize reliability to address the trend of miniaturization. All...

MEMS Microphone Interfaces: Analog vs. Digital Outputs

The utilization of MEMS microphones presents an opportunity to incorporate sophisticated communication and monitoring capabilities into a wide range of devices.

MEMS versus ECM: Comparing Microphone Technologies

Two of the most commonly used technologies in microphone construction are micro-electro-mechanical system (MEMS) microphones and electret condenser microphones (ECM), with numerous...

Guide to VNA Automation in MATLAB Using the TCP Interface

In this guide, advantages of using MATLAB with TCP interface is explored. The how-to is also covered for setting up automation language using a CMT VNA.