Phase noise measurement using a interferometric measurement technique

Jan. 14, 2025

This paper describes the measurement of additive/residual phase noise of power amplifiers or multipliers for automotive radar sensors at 80 GHz using the interferometric measurement approach in combination with a phase noise and VCO tester.

Learn how to use the interferometric measurement approach in combination with a phase noise test system to characterize the additive/residual phase noise of amplifiers down to -150 dBc/Hz at 100 kHz to offset the microwave range at 80 GHz

This content is sponsored by:

Continue Reading

Selecting the Right Voltage Measurement When Testing Batteries

Phase-Noise Modeling, Simulation, and Propagation in Phase-Locked Loops (Part 1)

Powering next-generation ADAS processors with TI Functional Safety-Compliant buck regulators

The TPS62883-Q1 buck converter delivers up to 30A, supports stackable architectures for over 100A, and meets ASIL D functional safety standards for ADAS. Its high accuracy, flexible...

RECOM’s RMOD600-EW series high power density module for E-mobility and industry vehicles

RECOM's RMOD families are extremely robust plug-and-play modules used to generate the low voltage network from a vehicle’s traction battery.

TPSI2140-Q1: Automotive 1400-V, 50-mA, isolated switch with 2-mA avalanche rating

TI’s TPSI2140-Q1 is a Automotive 1200-V 50-mA isolated switch with 2-mA avalanche rating. Find parameters, ordering and quality information

Gallium nitride (GaN) Ics

Maximize power density and efficiency with our portfolio of GaN power devices for every power level